User Manual

Amplifier Kit
BreezeNET PRO.11 Series 0-2 User’s Guide
It is very important to waterproof the RF connectors on the
amplifier. However, it is recommended that you do not seal the connectors until after all system
tests have been performed. Be sure to use the high quality weather resistant vapor wrap included
with you amplifier kit to seal all the outside connections.
The DC Power Injector is not in a waterproof enclosure and must be protected from the weather. It
can be permanently mounted to a surface using the mounting flanges. Refer to the BreezeCom
Amplifier Installation Details diagram shown later in this manual.
NOTE: When using the 24dB gain dish antenna in the United States, the external
filter (P/N: SPF-1) must be installed to comply with FCC emission
requirements.
Amplifier Connections and Indicators
Transmit
LED:
This LED glows RED in transmit mode.
Receive LED: This LED glows GREEN in the “receive” mode. (When DC power is supplied, the unit defa
u
mode).
DC Injector
Connection:
This “N” Female connector is connected to the DC Power Injector via the transmission cabl
e
Antenna
Connection:
This “N” Female connector connects to the antenna with a short length of coax cable.
AMP
MAST