User Manual

Appendix
BreezeNET PRO.11 Series 8-4 User’s Guide
Technical Specifications
Access
Points
AP-10 PRO.11
Station
Adapters
SA-10/40 PRO.11
Ethernet
Bridges
WB-10 PRO.11
Configuration and Management
Configuration and Setup Via Local Monitor port (serial RS-232)
SNMP management
- SNMP agents
- Access via
MIB II, Bridge MIB, WLAN MIB, and private MIB
Wired LAN, Wireless LAN
Site Survey Via Local Monitor port (serial RS-232)
Via SNMP
Front Panel Display LED indicators - Power on
- Wired LAN activity
- Wireless LAN synchronization
- Wireless LAN signal quality/Load
S/W upgradeable Through TFTP download
System Considerations
Range (Access Point to Station) Depends on rate and antenna cable length/quality.
(Accurate values must be calculated for specific installations. )
Refer to section 4.2.7, Using Outdoor Range Tables.
- Range - unobstructed with integrated
antennas
2000 ft. (600m)
- Range - unobstructed with external
antennas (models D and DE)
USA FCC - up to 6 miles
Europe ETSI - up to 2.5 km
Europe ETSI (DE model only) - up to 5 km
Non-Regulated - 30 km and above
- Range - Office Environment Up to 500 ft. (150m)
Maximum no. of APs per wired LAN Unlimited
Maximum no. of co-located (overlapping)
cells (Access Points)
15
Data Rate - over the air
- nominal net
- aggregate
1, 2, or 3 Mbps
Up to 2 Mbps
Over 5 Mbps with overlapped cells
High Speed roaming up to 60 mph (90 kph)
Load sharing support
yes (with WIX
)
Dynamic rate selection based on radio
medium quality
Yes