User's Manual

Appendix
BreezeNET PRO.11 Series 8-34 User’s Guide
ToDS
This bit is set to 1 when the frame is addressed to the AP for forwarding to
the Distribution System (including the case where the destination station is
in the same BSS, and the AP is to relay the frame).
The Bit is set to 0 in all other frames.
FromDS
This bit is set to 1 when the frame is received from the Distribution System.
More Fragments
This bit is set to 1 when there are more fragments belonging to the same
frame following the current fragment.
Retry
This bit indicates that this fragment is a retransmission of a previously
transmitted fragment. This is used by the receiver station to recognize
duplicate transmissions of frames that may occur when an Acknowledgment
packet is lost.
Power Management
This bit indicates the Power Management mode that the station will be in
after the transmission of this frame. This is used by stations which are
changing state either from Power Save to Active or vice versa.
More Data
This bit is used for Power Management as well as by the AP to indicate that
there are more frames buffered for this station. The station may decide to
use this information to continue polling or even changing to Active mode.
WEP
This bit indicates that the frame body is encrypted according to the WEP
algorithm
Order