User's Manual

Introduction To The BreezeNET PRO.11 Series
BreezeNET PRO.11 Series 1-7 User’s Guide
Balancing algorithm to divide the stations equally between the available co-
located Access Points.
The BreezeNET Access Point contains an embedded SNMP agent enabling
effective management by BreezeVIEW or any standard SNMP management
station. Software upgrades can be downloaded by TFTP protocol via the
wired LAN or wireless LAN.
1.2.2. Workgroup Bridge
The BreezeNET Workgroup Bridge is a high-speed, wide-range wireless
LAN bridge that provides connectivity to remote Ethernet networks.
Figure 1.1: WB-10D PRO.11 with Two
External Antenna Connector Ports
Disclaimer: This diagram is for illustrative purposes only. It should not be
confused with the transceiver operating in a standalone mode. When this
diagram is in use, the transceiver will be used in conjunction with amp
model AMP-2440-250/500 and the antennas listed in this manual.
The Workgroup Bridge communicates with the BreezeNET Access Points of
the remote LANs effectively creating an extended wireless network
spanning sites situated up to 6 miles apart (in Europe this range is limited by
ETSI regulations to 2.5 Km.). In this way a central Ethernet LAN may be
connected with one or more branch office LANs.
In addition, an island consisting of a Workgroup Bridge together with an
Access Point can work as a relay. Transmissions from the central LAN and
from the remote LAN are relayed via the island located between them. This
configuration effectively doubles bridge range.