User's Manual

Introduction To The BreezeNET PRO.11 Series
BreezeNET PRO.11 Series 1-8 User’s Guide
Workstations that can be connected to the wireless LAN include PCs, X-
Terminals, Digital, SUN, HP, IBM, and Apple computers, and any other
device that supports Ethernet. The unit is transparent to the workgroup
devices’ hardware, software, and network operating system.
The BreezeNET Workgroup Bridge contains an embedded SNMP agent and
software downloading capabilities enabling effective management. Software
upgrades are downloaded using TFTP protocol via the Ethernet ports or via
the wireless LAN and Access Point.
1.3. Extending Range with the AMP2440
To extend the range of the AP10-D or WB-10D, the AMP2440-250 or
AMP2440-500 is used. These devices amplify the RF output and receive
power to allow long range connections or connections with longer cable
runs. The diagram below shows a typical installation of the BreezeNet and
AMP2440. (See the addendum at the end of this manual for instructions on
how to install the AMP2440).
1.4. Antenna Selection
BREEZECOM AMPLIFIER INSTALLATION DETAILS
DC POWER
INJECTOR
BreezeNet
Radio
To Ethernet
Hub
UTP Cable
5ft. LMR-400
RF + DC
N-Male to
N-Male adapter
to attach to the
N-Female on
cable
Special SMA Right angle
Male connector
ANTENNA
Omni-directional (shown), or
Grid or Panel Antennas (not shown)
AMP2440
(mounted to mast with U-Bolt)
N-Male connector
Transmission Line
LMR-400, or other low loss cable to radio room
Mast
Drip
Loop
Coax Cable to
Pole Mounted
Amplifier
Barrel Plug
110/220 VAC
AC Main Power
110/220 VAC
AC Main Power
*
Filter is required in the United States when the 24dB grid dish
antenna is used in order to comply with FCC emission requirements.
N-Male to
N-Male adapter
to attach to the
N-Female on
cable