User's Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-1 User’s Guide
3. DEVICE SETUP AND MANAGEMENT
This chapter explains how to access the local terminal program, and how to
use the terminal program to setup, configure, and manage most BreezeNET
PRO.11 Series units.
The BreezeNET PRO.11 Series is a plug-and-play solution and operates
immediately after physical installation without any user intervention.
However, you can adapt the system to your particular needs using the local
terminal. In addition, all products in the series contain an SNMP agent and
are configurable remotely via the network.
Note: Reset the unit after making configuration changes so that the changes will
take effect.
3.1. Accessing and Using Local Terminal
Management
⇒⇒ To access Local Terminal Management:
1. Use the Monitor cable (supplied with the Access Point) to connect
the MON jack on the rear panel of the unit to the COM port of your
ASCII ANSI terminal or PC.
2. Run a terminal emulation program (such as HyperTerminal™).
3. Set up communication parameters to the following:
• Baud Rate: 9600
• Data Bits: 8
• Stop Bits: 1
• Parity: None
• Flow Control: NONE
• Connector: Connected COM port.
4. Press Enter. The main menu appears.