User's Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-2 User’s Guide
⇒⇒ To use Local Terminal Management:
1. Press an option number to open/activate the option. You may need
to press Enter in some cases.
2. Press Esc to exit a menu or option.
3. Reset the unit after making configuration changes.
3.2. Configuration Screens
Listed below are the menus, sub-menus, and parameters/options in the
terminal program. Default values are listed where applicable. Numbers in
the table below indicate how to reach each option. For example, to reach the
1.2.1 IP Address option, start at the main menu, press 1, then 2, and then 1.
Menu Sub-Menu Parameter/Option Default Values
1. System
Configuration
1.1 Station
Status
• Unit’s Mode
• Unit’s H/W Address
• Unit’s WLAN Addr (SA-10/40,WB-10)
• Station Status (SA-10-40, WB-10 Only)
• Total Number of Associations since
last reset (SA-10-40, WB-10 Only)
• Current Number of Associations (AP)
• Maximum Number of Associations
since last reset (AP)
• Current Number of Authentications
(AP)
• Maximum Number of Authentications
since last reset (AP)
1.2 IP and
SNMP
Parameters
1.2.1 IP Address
1.2.2 Subnet Mask
1.2.3 Default Gateway Address
1.2.4 SNMP Traps
1.2.5 Display Current Values
Not set
Not set
Not set
Enabled
1.3 Wireless
LAN (WLAN)
Parameters
1.3.1 Hopping Sequence (AP Only)
1.3.2 Hopping Set (AP Only)
1.3.3 ESSID
1.3.4 Maximum Data Rate
1.3.5 Transmit Antenna
1.3.6 Mobility
1.3.7 Load Sharing
1.3.8 Preferred AP (SA-10/40, WB-10 Only)
1.3.A Display Current Values
1 (FCC standard)
1 (FCC standard)
ESSID1
3Mbps
Use 2 Antennas*
Low
Disabled**
Not set
1.4 Bridging 1.4.1 LAN-WLAN Bridge Mode (AP Only)
1.4.2 Intelligent Bridging Period (AP Only)
1.4.3 IP Filtering
1.4.4 Tunneling
1.4.5 Broadcast Relaying
1.4.6 Unicast Relaying
Reject Unknown
15 sec
Disabled
Both
Enabled
Enabled