User's Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-8 User’s Guide
ESSIDESSID of the unit (up to 32 printable ASCII characters). The
ESSID is a string used to identify a WLAN. This ID prevents the
unintentional merging of two co-located WLANs. A station can only
associate with an AP that has the same ESSID. Use different ESSIDs to
segment the WLAN network and add security.
Note: The ESSID is case-sensitive.
Maximum Data RateMaximum data rate of the unit. BreezeNET
PRO.11 units operate at 1 Mbps, 2 Mbps or 3 Mbps. The unit adaptively
selects the highest possible rate for transmission. Under certain
conditions (compatibility reasons or for range/speed trade-off) you may
decide to limit the use of higher rates.
Transmit Antenna – Which antennas are used for transmission. During
reception, a BreezeNET PRO.11 unit dynamically selects the antenna
where reception is optimal. In contrast, before transmission the unit
selects the antenna from which it will transmit. It usually uses the
antenna last used for successful transmission. In models with external
antennas, sometimes only a single antenna is used. In this case, Transmit
Antenna should be configured to transmit only from that single antenna.
Similarly, models using a booster or an LNA use only a single antenna
for transmission. There are three possibilities for configuration:
0 Use Two Antennas
1 Use Antenna No. 1 only
2 Use Antenna No. 2 only
MobilityBreezeNET PRO.11 stations optimize their roaming
algorithms according to the mobility mode parameter. For example, a
stationary station is more tolerant of bad propagation conditions. It
assumes that this is a temporary situation and is not caused by the station
changing position. Initiating a roaming procedure in such a case would
be counter-productive. In general, Wireless stations can be used in one
of three mobility modes:
High – For stations that may move at speeds of over 30 km per hour.
Medium – For stations that may move at speeds of over 10 km per
hour, but not over 30 km per hour.