User's Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-23 User’s Guide
Threshold” parameter (see “Roaming” on section 3.5.2).
• Total: The number of frames set as the “Roaming Decision Window” -
10 in the example shown above (see “Roaming” on section 3.5.2).
• avr RSSI: The average RSSI level of the total number of frames (only
includes the frames received without errors).
• bcn cnt: (Beacon Count) - How many dwells have passed since the last
beacon has been received.
• Load: The number of stations currently associated with the descried AP.
This parameter will be displayed only when “Load Sharing’” (page 24)
is Enabled.
3.6.5. Using the Site Survey Software
⇒⇒ To use the Site Survey Software:
1. Roughly, align the antennas on either side of the link before
starting the Site Survey procedure.
2. Verify that the Ethernet cables are disconnected from both units.
3. Press 1 to go to the Operation mode screen. Set the units on either
side of the link to either receive (option 1) or transmit (option 2)
packets (one unit should be set to transmit and the other to receive).
4. Start the survey by selecting option (2) in the Survey Software
menu in both units. When performing a site survey from a station
to an AP (transmitting from the station to the AP), always begin
with the station (select option (2) on the station).
5. On the transmit side, a screen appears displaying a table with the
number of packets and the frequency at which each packet was
transmitted (refer to Figure 3.5). This list is updated continuously.
Select option (3) to stop sending packets.