User's Manual

Planning and Installing Wireless LANs
BreezeNET PRO.11 Series 4-5 User’s Guide
The WB-10 PRO.11 also enables connectivity between a wireless LAN and
individual workstations or workgroups located outside the LAN. The
WB-10 PRO.11 enables these wireless stations in its coverage area to
communicate with the wireless LAN and gain access to all of the network
resources such as file servers, printers and shared databases.
Figure 5.2: Wireless Bridging Between Two or More Wireless LAN Segments
4.1.1.5 Setting Up a Single BreezeNET Cell
⇒⇒ To set up a single BreezeNET cell:
1. Install the Access Point (refer to section 2, Basic Installation). Be
sure to position the Access Point as high as possible.
Note: It is not necessary at this point to connect the Access Point to an Ethernet
backbone, since Access Points continuously transmit signals (beacon
frames) whether they are connected to an Ethernet backbone or not.
2. Install a Station Adapter (refer to section 2, Basic Installation).
3. Check the LED indicators of the front panel of the Station Adapter,
to check signal strength.
4. Make any necessary adjustments, for example: