User's Manual

Planning and Installing Wireless LANs
BreezeNET PRO.11 Series 4-8 User’s Guide
5. Install a Station Adapter or SA-PCR Card on a workstation.
6. Position the wireless workstation approximately the same distance
from the two Access Points.
7. Temporarily disconnect the first Access Point from the power
supply. Verify radio signal reception from the first Access Point.
View the LED indicators of the front panel of the Station Adapter,
or the Site Survey application of the SA-PCR Card, to check signal
strength of the first Access Point.
8. Disconnect the second Access Point from the power supply and re-
connect the first Access Point. View the LED indicators of the front
panel of the Station Adapter, or the Site Survey application of the
SA-PCR Card, to check signal strength of the second Access Point.
7. If necessary, adjust the distance between the Access Points so the
coverage areas overlap.
8. Continue setting up overlapping cells until the required area is
covered.
Note: It is not necessary at this point to connect the Access Points to an Ethernet
backbone, since Access Points continuously transmit signals (beacon
frames) whether they are connected to an Ethernet backbone or not.