User's Manual

Upgrade Procedure
BreezeNET PRO.11 Series 6-1 User’s Guide
6. UPGRADE PROCEDURE
Firmware upgrades to the unit's flash memory is done by a simple download
procedure using a TFTP application. Before beginning an upgrade, be sure
you have the correct files and latest instructions. Upgrade packages can be
obtained at the BreezeCOM web site: www.breezecom.com.
In general terms, upgrading includes the following steps:
1. Set up an IP connection to the device. You can verify working
connection using the Ping command.
2. Run TFTP software and connect to the device.
3. Use TFTP to download the erase file to the device Use the tables
below to determine the specific file to use, according to the unit’s
current version. This causes the flash memory to be cleared. Do not
reset the device now.
4. Use TFTP to download the software file to the device. Use the
tables below to determine the specific file to use, according to the
unit’s current version.
5. The unit resets itself and comes up with the new upgraded version.
Table 7.1: Upgrade Files
Software Download File Name
Current Version
of Unit
Flash Erase
File Name
AP-10 SA-10, SA-40, WB-10
3.2, 3.38, 3.42, 3.50 download eanaf eansf
3.52, 4.204 erase eanafb eansfb
3.62, 4.211, 4.310 erase_fw ap_fw sawb_fw
The current version and type of the unit determine the files used for
upgrade. For example, when upgrading an AP-10 from version 3.52 to
version 4.310, use the erase and eanafb files.
When upgrading a SA-10 from version 3.62 to version 4.310, use the
erase_fw and sawb_fw files.
When upgrading an AP-10 from version 4.211 to version 4.310, use the
erase_fw and ap_fw files.