User's Manual

Professional Installation for Model BreezeNET PRO.11/AMP1440 System
Intended use
All BreezeCOM devices are used to provide high speed data connections to remote networks.
The BreezeNET PRO.11/AMP2440 System is not intended nor is it marketed for home use. It is
designed for use by commercial businesses only.
Installation
The installation of the Model BreezeNET PRO.11/AMP2440 System will be controlled.
BreezeCOM will ensure that the professional doing the installation is made aware of the
requirements so that the final installation complies with FCC rules. Specifically the installer must
ensure that the ERP of the transmitting antenna does not exceed the requirements of paragraph
15.247(b) by using an HP 436A power meter and an HP 8481H power sensor. Power meters
that measures average power must not be used when installing the transmitter, amplifier and
antenna combination.
It will be explicitly explained to the professional installer that they will install a 250mW or 500mW
version of the amplifier based on the antenna to be used in the installation. (See attached chart).
The output power of the BreezeNET PRO.11/AMP2440 System is limited to 250mW or 500mW,
regardless of the loss of cable between the DC injector and the amplifier any length or type of 50
ohm coax transmission can be used.
Since BreezeNET PRO.11/AMP2440 System are shipped labeled as "BreezeNET
PRO.11/AMP2440-250 System" for a 250mW output and a "BreezeNET PRO.11/AMP2440-500
System" for a 500mW maximum output, the installer will be aware of the output power of the
system. Further, all installations of the Model BreezeNET PRO.11/AMP2440 System will require
topographic analysis, site survey and link budget calculation. Therefore, the system will require a
BreezeCOMed trained professional to do the installation.
This ensures compliance with the maximum transmitter ERP allowed with the antenna provided
as a system.
The following statement is in the BreezeNET user's guide (section 5.5.1) and is also supplied as
a separate sheet with each device sold:
"Professional Installers Only :
Detached antennas, whether installed indoors or out, should be installed ONLY by experienced
antenna installation professionals who are familiar with local building and safety codes and,
wherever applicable, are licensed by the appropriate government regulatory authorities. Failure to
do so may void the BreezeNET product warranty and may expose the end user to legal and
financial liabilities."
"Regulations regarding maximum antenna gains vary from country to country. It is the
responsibility of the end user to operate within the limits of these regulations and to ensure that
the professional installer is aware of these regulations, as well. "