User`s guide

BreezeNET DS.11 Series User’s Guide
3-28
♦ Packet timeout: Defines the time (in seconds) it takes for a packet to timeout.
The range is from 1 to 30 seconds with a default of 3 seconds.
♦ Packet Retries: Defines the number of times that a packet will be sent after it
timeouts in a TFTP session. The range is from 1 to 5 retries with a default of
3 retries.
♦ Session Retries: Defines the number of times a TFTP session will be repeated
before the firmware upgrade operation is designated a failure. The range is 1-5
retries with a default of 3 retries.
Multiple Unit Configuration Mode
This feature enables configuration parameters to be downloaded to multiple units
simultaneously. When you select this option from the Options menu, all
configuration windows are displayed as write-only. Irrelevant parameters are
disabled. The multiple configuration mode does not include the General
Parameters tab that is not supported by units running firmware version 3.0 or
lower.
NOTE:
The Configuration Utility does not resolve the topology of the cell. Therefore, multiple unit configuration
operations should be done at the location where the BUs are located.
Select the units whose parameters should be modified from the list box on the
left-hand side of the window. Use Shift-click and/or Ctrl-click to select multiple
units.
Enter the configuration parameter values and click Apply. The following window is
displayed.
Figure 3-20: Multiple Configuration Mode