Specifications

Chapter 2 - Installation Installing the Outdoor Unit
BreezeNET B 29 System Manual
2 Unscrew the top nut from the waterproof seal.
3 Route a straight Category 5E Ethernet cable (8-wire, 24 AWG) through both
the top nut and the waterproof seal
.
4 Insert and crimp the RJ-45 connector. Refer to Appendix C for instructions on
preparing the cable.
5 Connect the Ethernet cable to the outdoor unit RJ-45 connector.
6 Replace the waterproof seal and then the top nut. Make sure that the external
jack of the cable is well inside the waterproof seal to guarantee a good seal.
7 Route the cable to the location selected for the indoor equipment.
8 Assemble an RJ-45 connector with a protective cover on the indoor end of the
indoor-to-outdoor cable.
Figure 2-9: The Waterproof Seal
NOTE
Use only Category 5E 4x2x24# FTP outdoor cables from an approved manufacturer. See list of
approved cables and length limitations in
Section 2.1.2.