User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Switch Command
Alvarion BreezeNET B130/B300 GigE 88 Operational User Manual
 start|stop - starts/stops a specified switching group.
 restart - restarts the switching group (same as "switch group GROUPID start;
switch group GROUPID start" set of commands). The command is used to
clean the switching group database.
 remove - deletes a specified switching group from the switch configuration.
Examples:
switch group 3 dump eth0
switch group 5 start
In order to access the switches which are connected wirelessly from eth*
interfaces (e.g. workstations which are connected using wired interfaces to one of
the units) on such units (border units of the wireless network) one of the groups
should be selected as admin group. All packets destined for any of the switches in
wireless network will be sent by this group.
switch admin-group {GROUPID|0}
MAC Switch supports STP protocol, namely two its versions: STP and RSTP. To
implement this feature the following switch commands are introduced:
switch group GROUPID stp { off | on | dump }
This command with off/on options enables or disables STP for the group. Dump
option allows to see STP state of the group.
"switch group GROUPID stp dump" command output: