User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Switch Command
Alvarion BreezeNET B130/B300 GigE 93 Operational User Manual
switch list MACGROUP1 MACGROUP1 mac add 00:01:02:03:04:05
00:11:12:13:14:15
switch list VGROUP numrange add 10 20-30 40
switch list IP_NET3845 match add 'arp net 195.38.45.64/26 ||
ip net 195.38.45.64/26'
switch group 5 rule 10 src MACGROUP1 vlan VGROUP match
IP_NET3845 deny
switch group 5 rule 20 dst MACGROUP1 vlan VGROUP match
IP_NET3845 deny
switch group 5 permit
switch group 1 rule 1 setpri 10
In order to configure a default decision for group/interface the following command
should be used:
switch {group GROUPID | interface IFNAME}
{deny | permit}
3.7.5 Control Commands
Syntax:
switch resynchronize
switch trace { off | on | verbose }
switch stptrace { off | on }
switch {dump [WILDCARD]|MACADDRESS}
switch local-tag TAG
switch igmp-snooping dump [detail]
switch igmp-snooping lmqt Value
switch igmp-snooping gmi Value
switch igmp-snooping static-add MCAST IF_NAME [MAC]
switch igmp-snooping static-del MCAST IF_NAME [MAC]
switch igmp-snooping querier group N [source X] [mcast X]
[vlan N] {start|stop}