User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Switch Command
Alvarion BreezeNET B130/B300 GigE 95 Operational User Manual
The "clear" option clears the switch statistic. The "help" option shows a list of the
descriptions of the drooped packets reasons used in the switch statistics
command output.
The following command allows setting the maximum allowed number of records in
the switch MAC-address table:
switch maxsources (MAXSOURCES|0)
The default number of records is 5000. When the value "0" is used the number of
records is set to minimum possible of 500.
Local packets generated by the device itself do not belong to any switch group.
Therefore, by default, they are sent into the wired interface (eth*) untagged. The
following command allows assigning the local packets with a VLAN tag:
switch local-tag TAG
The packets not belonging to any switch group will be sent into the wired interface
with the VLAN value equal to the value of the "local-tag" parameter. And
vice-a-versa, packets received via the wired interface and having their VLAN value
equal to the "local-tag" parameter will be processed as local ones.
The "local-tag" parameter is also called a Management VLAN as it makes the
device access and configuration possible only via the defined VLAN.
switch strict-admin [(on|off)]
By default, the device in switch mode process the packets that is destined to it
itself regardless of the switch group they belong to (switch strict-admin off).
However, by using "switch strict-admin on" command one can force the device to
accept such packets when they come in the admin-group only.
switch igmp-snooping dump [detail]
This command allows to see a list of IGMP hosts which are subscribed on Internet
Protocol multicast group.