User manual
Chapter 4 - Layer 3 Command Set - IP Networking Qm Command (QoS Configuration)
Alvarion BreezeNET B130/B300 GigE 113 Operational User Manual
16 (the lowest). Default value is 0 therefore when setting another value it is
possible only to lower the priority.
latency=N determines the maximum time for the packets to stay in the
channel. If a packet is waiting in a queue of the channel more than this time
then it is discarded. Measured in milliseconds. To disable set the parameter to
0.
pri=P Sets priority level of the specified channel (0..16). Smaller values
correspond to greater priority levels. Two special values are available: "-1" -
sets the lowest priority, "-2" - deletes the prioritization from the logical
channel.
[no]strict Sets a QM policy that will be applied to current channel. "Strict
Priority" policy is when packets from queue with lower priority are not
processed before queue with higher priority is not empty. "Weighted Fair
Queuing" policy (by default) is when even if higher priority queue is not empty
packets from other queues will be processed in a distinct sequence relative to a
higher priority queue.
pps=T Sets the limit for the packets per second for the specified channel
to=addr redirects the whole stream to the specified IP-address irrespectively of
the present routing conditions. The specified address shall be directly
attainable through one of the device interfaces (without additional routing).
This may be useful when the device serves as a network access unit, and two
or more different clients want to access different providers through one unit.
vlan=N, dot1p=N, dscp=N manipulates DSCP and/or 802.1p labels. Value
"-1" deletes the parameter:
» DSCP (valid values are 0-63) sets to 0 (zero).
» 802.1p priority (valid values are 0-7) sets to 0 (zero) and, if VLAN ID isn't
introduced, is deleted with VLAN header.
» VLAN ID (valid values are 0-4095) is deleted with VLAN header regardless
of 802.1p priority.
If several of the above parameters are specified in the same command then speed
limitation is applied first then redirection and only then priority. If vlan and
dot1p parameters are specified in the same command then vlan is processed
first.