User manual

Chapter 4 - Layer 3 Command Set - IP Networking ARIP
Alvarion BreezeNET B130/B300 GigE 122 Operational User Manual
4.5 ARIP
4.5.1 Getting Started
ARIP module is a realization of a standard routing protocol RIP.
ARIP routing module support two RIP (Routing Information Protocol) versions -
RIP-1 and RIP-2.
Module configuration is performed by arip command.
4.5.2 Command language. Basic Principles
ARIP has its own command shell (CS). To start the ARIP module and enter the
shell, execute the following commands:
#1> arip start
#1> arip
RIP>
Commands entered in CS are not case-sensitive and can be shortened until
ambiguity appears. To get a quick hint you can press "?" at any time:
RIP>?
configure Configuration from vty interface
debug Set debugging print level
end End current mode and change to root mode
(CTRL+C).
exit Back to WANFleX command shell (CTRL+D).
help Print command list
no Negate a command or set its defaults
show Show running system information
RIP>
CS can work in different modes. Current mode is displayed along with command
prefix as "RIP(mode)#". For example, if configure command is entered, CS
switches to config mode:
RIP> configure
RIP(config)#