User manual

Chapter 4 - Layer 3 Command Set - IP Networking ARIP
Alvarion BreezeNET B130/B300 GigE 123 Operational User Manual
The following figure shows the transition scheme between different modes of CS.
One can set the necessary mode or execute commands without specially entering
into arip module. For example, if we consistently execute the following commands:
#1> arip configure
#1> arip router
#1> arip
RIP(config-router)#
while entering arip we will enter directly into necessary mode config-router (as it is
shown in the example).
Every mode has its own set of commands. The following commands are available
in any mode:
 Help - prints the list of commands for the current mode
 No - Negate a command or set its defaults
 End - goes back from the current mode to the base mode
 Exit - exit to WANFleX CLI from RIP CS
Debug level command sets debugging level from 0 to 255.
At the start, CS is in the base mode which has a set of commands to view current
router state. In order to switch to the configuration mode you should have
superuser rights. After entering a configuration mode, the configuration is being
blocked and entering in this mode from other terminal (e.g. other telnet session) is
Figure 4-4: ARIP Transition