User manual

Chapter 4 - Layer 3 Command Set - IP Networking ARIP
Alvarion BreezeNET B130/B300 GigE 124 Operational User Manual
prohibited. In order to avoid a "dead" block of the session, CS automatically quits
the configuration mode after five minutes of no activity.
Context help is always available using "?". For example:
RIP> config
RIP(config)#?
access-list Add an access list entry
clear Reset functions
end End current mode and change to root mode
(CTRL+C).
exit Back to WANFleX command shell (CTRL+D).
help Print command list
interface Select an interface to configure
key Authentication key management
no Negate a command or set its defaults
prefix-list Build a prefix list
route-map Create route-map or enter route-map command
mode
router Enable a routing process
show Show running system information
stop stop
RIP(config)# interface?
IFNAME Interface's name
RIP(config)# interface eth0
RIP(config-if)#?
authentication Authentication control
description Interface specific description
end End current mode and change to root mode
(CTRL+C).
exit Back to WANFleX command shell (CTRL+D).
help Print command list
no Negate a command or set its defaults