User manual

Chapter 4 - Layer 3 Command Set - IP Networking ARIP
Alvarion BreezeNET B130/B300 GigE 125 Operational User Manual
receive Advertisement reception
send Advertisement transmission
show Show running system information
split-horizon Perform split horizon
RIP(config-if)#
After quitting CS using "exit" command (or Ctrl+D), CS stays in the last active
mode.
Commands may have different parameters. Commands parameters are specified
in several formats. Parameter's format is described in the context help or in the
list of commands (help command) in the following way:
 A.B.C.D - a parameter is set in IP-address format. Example: 192.168.0.15
 WORD - a set of characters with no spaces
 <1-N> - a parameter is set as a decimal number in a range from 1 to N
 A.B.C.D/M - a parameter is set in a format IP-address/subnet mask length.
Example: 192.168.0.0/24
 IFNAME - name of a physical network interface. Example: eth0
If a parameter can be written in different formats, it will be displayed in round
brackets, the options are separated by "|" character. Example:
(A.B.C.D|<0-4294967295>).
If a parameter is optional, it is put into square brackets: "[]".
Any command may contain "no" prefix. Having this prefix in the command means
deleting a corresponding parameter from the configuration.
4.5.3 Start/Stop of RIP
Start of RIP router is executed by the following command:
RIP start
In order to stop RIP, execute the following command in config mode:
stop (daemon|clear)
Example:
> arip