User manual

Chapter 4 - Layer 3 Command Set - IP Networking ARIP
Alvarion BreezeNET B130/B300 GigE 134 Operational User Manual
 The update timer is 30 seconds. Every update timer seconds, the RIP process
is awakened to send an unsolicited Response message containing the complete
routing table to all neighboring RIP routers.
 The timeout timer is 180 seconds. Upon expiration of the timeout, the route
is no longer valid; however, it is retained in the routing table for a short time so
that neighbors can be notified that the route has been dropped.
 The garbage collect timer is 120 seconds. Upon expiration of the
garbagecollection timer, the route is finally removed from the routing table.
The following command in config-router mode allows the default values of the
timers listed above to be changed:
timers basic update timeout garbage
The no timers basic command will reset the timers to the default settings listed
above:
no timers basic
4.5.9 Configuration View
To review RIP configuration there are several commands in the basic mode of CS:
show access-list
This command shows information about access lists.
show memory
This command shows information about memory usage.
show rip
This command shows current RIP configuration. Viewing Information about
timers, filters, version, interfaces, on which RIP is enabled.
show route
This command lists route table.