User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 141 Operational User Manual
4.7 OSPFv2 (Dynamic Routing Protocol
Module)
4.7.1 Getting Started
OSPF protocol is widely used routing protocol for IP networks. Basic principles
that form a current version of protocol are outlined in RFC 2328. OSPF protocol is
a classical Link-State protocol which delivers the following functionality:
 no limitation for the network size
 routes information update sending using multicast addresses
 high speed route definition
 using authentication procedure while routes updating
 classless routing support
4.7.2 Command Language. Basic Principles
OSPF has its own command shell (CS). To enter the shell, execute the following
command:
#1> ospf
OSPF>
Commands entered in CS are not case-sensitive and can be shortened until
ambiguity appears. To get a quick hint you can press "?" at any time:
OSPF>?
configure Configuration from vty interface
end End current mode and change to root mode
(CTRL+C).
exit Back to WANFleX command shell (CTRL+D).
help Print command list
show Show running system information
OSPF>