User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 142 Operational User Manual
CS can work in different modes. Current mode is displayed along with command
prefix as "OSPF(mode)#". For example, if configure command is entered, CS
switches to config mode:
OSPF> configure
OSPF(config)#
The following figure shows the transition scheme between different modes of CS.
Every mode has its own set of commands. The following commands are available
in any mode:
 Help - prints the list of commands for the current mode
 Alias - sets symbolic name for the current configurable parameter
 End - goes back from the current mode to the base mode
 Exit - exit to WANFleX CLI from OSPF CS
Debug level command sets debugging level from 0 to 255.
At the start, CS is in the base mode which has a set of commands to view current
router state. In order to switch to the configuration mode you should have
superuser rights. After entering a configuration mode, the configuration is being
blocked and entering in this mode from other terminal (e.g. other telnet session) is
prohibited. In order to avoid a "dead" block of the session, CS automatically quits
the configuration mode after five minutes of no activity.
Context help is always available using "?". For example:
Figure 4-5: OSPF Transition