User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 143 Operational User Manual
OSPF> config
OSPF(config)#?
access-list Add an access list entry
alias Set symbolic mode
clear Reset functions
debug Set debugging print level
end End current mode and change to root mode
(CTRL+C).
exit Back to WANFleX command shell (CTRL+D).
help Print command list
interface Select an interface to configure
no Negate a command or set its defaults
prefix-list Build a prefix list
route-map Create route-map or enter route-map command
mode
router Enable a routing process
show Show running system information
stop stop
OSPF(config)# interface?
IFNAME Interface's name
OSPF(config)# interface eth0
OSPF(config-if)#?
authentication Enable authentication on this interface
authentication-key Authentication password (key)
cost Interface cost
dead-interval Interval after which a neighbor is
declared dead
description Interface specific description
end End current mode and change to root mode
(CTRL+C).
exit Back to WANFleX command shell (CTRL+D).
hello-interval Time between HELLO packets