User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 144 Operational User Manual
help Print command list
message-digest-key Message digest authentication password
(key)
mtu <40-65535>
network Network type
no Negate a command or set its defaults
priority Router priority
retransmit-interval Time between retransmitting lost link
state
show Show running system information
transmit-delay Link state transmit delay
OSPF(config-if)#
After quitting CS using "exit" command (or Ctrl+D), CS stays in the last active
mode.
Commands may have different parameters. Commands parameters are specified
in several formats. Parameter's format is described in the context help or in the
list of commands (help command) in the following way:
 A.B.C.D - a parameter is set in IP-address format. Example: 192.168.0.15
 WORD - a set of characters with no spaces
 <1-N> - a parameter is set as a decimal number in a range from 1 to N
 A.B.C.D/M - a parameter is set in a format IP-address/subnet mask length.
Example: 192.168.0.0/24
 IFNAME - name of a physical network interface. Example: eth0
If a parameter can be written in different formats, it will be displayed in round
brackets, the options are separated by "|" character. Example:
(A.B.C.D|<0-4294967295>).
If a parameter is optional, it is put into square brackets: "[]".
Any command may contain "no" prefix. Having this prefix in the command means
deleting a corresponding parameter from the configuration.