User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 161 Operational User Manual
area (A.B.C.D|<0-4294967295>) virtual-link A.B.C.D
(authentication|) (message-digest|null)
Authentication type can be specified for the whole area to which a network
belongs and a link by means of which OSPF packets are received. If
authentication is turned on for both interface and the area, the interface
authentication type will be used. In order to configure authentication type if it was
disabled for interface (link) one can configure authentication type for the area
using a command in config-router mode:
area (A.B.C.D|<0-4294967295>) authentication [message-digest]
If message-digest option is not specified, simple password authentication will be
enabled for the area.
As was mentioned before, area authentication type is applied only if interface's
authentication was totally disabled. However, interface's authentication
parameters will be used.
To turn on area authentication, use the following command in config-router mode:
no area (A.B.C.D|<0-4294967295>) authentication
4.7.10 Router Running Configuration View
To review current running configuration of the router there are several commands
in the basic mode of CS. In any mode of CS there is a command:
show running-config
This command shows a current router's configuration.
The configuration is shown as list of commands which brought the router to its
current state.
Example:
OSPF> show running-config
Current configuration:
interface eth0
interface eth1
interface lo0
interface null0
interface tun0