User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 162 Operational User Manual
network point-to-point
router
router-id 195.38.45.107
network 1.1.1.1/32 area 0.0.0.0
network 4.7.8.0/24 area 0.0.0.1
network 192.168.15.1/24 area 0.0.0.1
network 195.38.45.107/26 area 0.0.0.0
area 0.0.0.1 virtual-link 192.168.151.10
end
OSPF>
4.7.10.1 Neighbor
show neighbor [A.B.C.D] [detail]
As a parameter one can specify IP-address of a network interface (link), which
state and neighbor is to be shown. If this parameter is not specified the command
shows a summary information for all interfaces.
Example:
OSPF> show neighbor
Neighbor ID Pri State Dead Time Address
Interface
9.1.1.8 1 Full/DROther 00:00:32 1.1.1.2
tun0:1.1.1.1
OSPF>
Table columns:
 Neighbor ID - neighbor router-id
 Pri - priority