User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 163 Operational User Manual
 State - current state/status. This parameter may be of the following value:
» Init. This state means that a Hello packet was recently received from a
neighbor with whom a 2-way connection is not yet established.
» 2-Way. A two-way connection is established between two routers. Starting
from here an adjacency relationship is initiated.
» ExStart. The first step in adjacency relationship establishing which sets
up master/slave relations.
» Exchange. In this state a router fully describes its link-state database by
sending packets to its neighbor.
» Loading. A state in which link-state database synchronization happens,
i.e. a request for new information is sent to the neighbor.
» Full. This state means that neighboring relationship is established and
list-state database is synchronized.
» Current status may be of the following values:
◊ DR - the router is selected to be a designated router.
◊ Backup - the router is selected as a backup designated router.
◊ DROther - the router is neither DR nor BDR
 Dead Time - the time left for neighbor acknowledgement packet.
 Address - neighbor's IP-address
 Interface - interface (link) through which information with neighbor is
exchanged.
If option detail is specified in the command, the information on neighbors is
shown in the detailed way.
4.7.10.2 Database
show database
The command shows a summary table with a database contents (LSA).