User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 165 Operational User Manual
This command is used to print access lists contents. If list identifier is not
specified, all lists are printed. For example:
OSPF> show access-list
IP access list any_network
permit any
IP access list net200
permit 192.168.200.0/24
Similar commands are used for prefix-lists output:
show prefix-list
show prefix-list WORD
4.7.10.4 Routing table
show route
This command prints a routing table. For example:
OSPF> show route
============ OSPF network routing table ============
N IA 1.1.1.1/32 [3] area: 0.0.0.1
via 192.168.15.1, eth0
N IA 1.1.1.2/32 [2] area: 0.0.0.1
via 192.168.15.1, eth0
N 4.7.8.0/24 [2] area: 0.0.0.1
via 192.168.15.1, eth0
N IA 9.1.1.0/24 [12] area: 0.0.0.1
via 192.168.15.1, eth0
N IA 192.168.0.0/24 [3] area: 0.0.0.1
via 192.168.15.1, eth0
N 192.168.15.0/24 [1] area: 0.0.0.1
directly attached to eth0
N IA 192.168.80.0/24 [12] area: 0.0.0.1
via 192.168.15.1, eth0
N 192.168.151.0/24 [1] area: 0.0.0.1