User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 166 Operational User Manual
directly attached to eth0
N IA 192.168.152.0/24 [2] area: 0.0.0.1
via 192.168.151.10, eth0
N IA 195.38.45.64/26 [2] area: 0.0.0.1
via 192.168.15.1, eth0
============ OSPF router routing table =============
R 192.168.151.10 [1] area: 0.0.0.1, ABR, ASBR
via 192.168.151.10, eth0
R 195.38.45.107 [1] area: 0.0.0.1, ABR
via 192.168.15.1, eth0
============ OSPF external routing table ===========
N E2 192.168.200.0/24 [1/7] tag: 0
via 192.168.151.10, eth0
OSPF>
This table consists of three parts:
1 OSPF network routing table. This section includes a list of acquired routers
for all accessible networks (or aggregated area ranges) of OSPF system. IA flag
means that route destination is in the area to which the router is not
connected, i.e. it's an inter-area path. In square brackets a summary metric
for all links through which a path lies to this network is specified. via prefix
defines a router-gateway, i.e. the first router on the way to the destination
(next hop).
2 OSPF router routing table.
3 OSPF external routing table. E2 flag points to the external link metric type
(E1 - metric type 1, E2 - metric type 2). External link metric is printed in the
format of <metric of the router which advertised the link>/<link metric>.
4.7.10.5 Interfaces information
show interface [INTERFACE]