User manual

Chapter 4 - Layer 3 Command Set - IP Networking OSPFv2 (Dynamic Routing Protocol Module)
Alvarion BreezeNET B130/B300 GigE 167 Operational User Manual
This command prints the information on network interfaces including virtual
links states. If interface name is not specified, all interfaces information will be
printed. For example:
OSPF> show interface
VLINK0 is up
Internet Address 192.168.151.10/24, Area 0.0.0.0
Router ID 192.168.151.10, Network Type VIRTUALLINK, Cost: 2
Transmit Delay is 1 sec, State Point-To-Point, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 00:00:08
Neighbor Count is 1, Adjacent neighbor count is 1
eth0 is up
Internet Address 192.168.151.10/24, Area 0.0.0.1
Router ID 192.168.151.10, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.151.10, Interface Address
192.168.151.10
Backup Designated Router (ID) 192.168.151.1, Interface
Address 192.168.151.1
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 00:00:05
Neighbor Count is 1, Adjacent neighbor count is 1
Internet Address 192.168.152.1/24, Area 0.0.0.2
Router ID 192.168.151.10, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.151.10, Interface Address
192.168.152.1
No backup designated router on this network