User manual

Chapter 4 - Layer 3 Command Set - IP Networking Td Command (Telnet Daemon)
Alvarion BreezeNET B130/B300 GigE 194 Operational User Manual
4.13 Td Command (Telnet Daemon)
Telnet daemon management.
Syntax:
td enable | disable RemoteHOST
td start | stop | flush
Description:
Telnet daemon makes it possible to remotely configure and manage a device, and
more generally to execute any operation system commands in the same way as it
is done on a local operator workstation.
Telnet daemon starts automatically when the device is switched on.
To stop the daemon operation, a td stop command shall be executed; a td start
command restarts the daemon.
By default, the daemon accepts SNMP connection establishment requests from
any host in the network. After executing one or several td enable RemoteHOST
commands, remote SNMP access becomes only possible from the explicitly
specified IP-addresses (one host specified per each td enable command, up to 10
hosts enabled simultaneously).
To retire from a remote host a previously granted access authorization, a td
disable command with its IP-address shall be executed.
Finally, a td flush command fully clears the current telnet daemon configuration.
Examples:
td enable 195.38.44.1
td enable 195.38.44.11
td start