User manual

Chapter 4 - Layer 3 Command Set - IP Networking Nat Command (Network Address Translation)
Alvarion BreezeNET B130/B300 GigE 196 Operational User Manual
x.x.x.x | 0.0.0.0
 -acl $NAME [public_addr|dhcp IFNAME] [enable|disable|delete] -
enables/disables or deletes a list of local networks and public address or dhcp
on the specified interface.
 -ml NUM - sets maximal links number
 -re [yes|no] - enables operation in reverse mode
 -i [yes|no] - enables ignoring of unknown incoming connections
 -sp [yes|no] - tries to keep original port numbers for connections
 -v [yes|no] - enables verbose mode that dumps packet information to system
log
 -s - enables NAT statistic
 -rpo - redirects a port (or several ports) for incoming traffic.
 -rpr - redirects packets of a given proto
 -ra - defines mapping between local and public addresses
 -pr - adds transparent proxying / destination NAT
 -dh [yes|no] - uses default H.323 ports for outgoing connections
 -hd - describes H.323 outgoing connection
 -po [yes|no] - sets "transparent proxy only" mode with no aliasing
 -skp port - sets the TCP port for the Skinny Station protocol
 -del rule_number - deletes nat rule
 ena - enables nat translation
 dis - disables nat translation