User manual

Chapter 4 - Layer 3 Command Set - IP Networking Trapd Command (SNMP Trapd Support)
Alvarion BreezeNET B130/B300 GigE 205 Operational User Manual
4.15 Trapd Command (SNMP Trapd Support)
SNMP trapd support module
Syntax:
trapd [-]dstaddr x.x.x.x[:PORT]
trapd [[-]agent x.x.x.x]
trapd [[-]gateway xxxxxxxxxxxx|auto]
trapd type TYPENAME enable|disable
trapd start|stop
Where possible, TYPENAMEs are:
topoGroup
mintGroup
ospfGroup
linkEvent
lostNeighborEvent
mintBitrate
mintRetries
mintSignalLevel
newNeighborEvent
snmpdAuthenticationFailureEvent
syslog
topoEvent
trapdColdStartEvent
Description:
SNMP protocol allows a network agent to send asynchronous traps when some
specific event occurs on the controlled device (object).
Trapd module performs a centralized information delivery from internal device
subsystems to the configured SNMP server.
SNMP server address is set by "trapd dstadd X.X.X.X" command (UDP port 162).
Agent's own address, which is set in SNMP-trap packet, is defined by "trapd
agent X.X.X.X" command. 127.0.0.1 address by default. "Trapd gateway