User manual

Chapter 4 - Layer 3 Command Set - IP Networking Trapd Command (SNMP Trapd Support)
Alvarion BreezeNET B130/B300 GigE 206 Operational User Manual
X.X.X.X" command defines gateway for traps. Trapd gateway automatic setting by
auto parameter is also possible.
Example:
trapd dstaddr 192.168.1.1
trapd start
The following traps are supported in the system:
 trapdColdStartEvent - this trap is sent when the units is powered up
 AuthenticationFailureEvent - this trap is sent in case of failure in SNMP
authentication
 Syslog - all new messages in the system log are sent as a trap
 topoGroup:
» topoEvent - full neighbor list is sent in case of any changes in number of
neighbors or their status
» newNeighborEvent - trap is sent when a new neighbor appears
» lostNeighborEvent - trap is sent when the neighbor is lost
 mintGroup:
» mintBitrate - trap is sent when the bitrate changes
» mintRetries - trap is sent Retries has changed by more than 10%
» mintSignalLevel- trap is sent Signal Level has changed by more than 10%
 linkEvent - this trap is sent when Ethernet state is changing. This trap
enables/disables sending two generic SNMP traps: linkUp and linkDown.