User manual

Chapter 4 - Layer 3 Command Set - IP Networking DHCP Server
Alvarion BreezeNET B130/B300 GigE 221 Operational User Manual
Moreover, there is a set of service options which although are included into a
summary table, they do not act as configuration parameters but act as service
parameters. The list of service options of DHCP server looks as follows:
 Subnet Mask
 Address Request
 Overload
 DHCP Msg Type
 DHCP Server Id
 Parameter List
 DHCP Message
 DHCP Max Msg Size
 Client Id
If you attempt to add one of these options to any division, the server will report an
error: ERR: This option cannot contain in the given division.
To control options which were requested by the client and given to him, one can
use the following command:
Syntax:
dhcpd interface <INTERFACE|*> show client <CLIENT_ID|*>
where
 INTERFACE - name of a network interface which information is requested
 CLIENT_ID - client's identifier, which information is requested. Instead of
interface name one can specify "*": this will print information for all clients and
interfaces. Instead of client's identifier it is permitted to specify "*": this will
print information about all clients for the specified interface. The information
is shown only for clients with given address lease from one of the scopes which
is attached to the specified interface.
Example: