User manual

Chapter 2 - General Purpose Command Set Telnet Command
Alvarion BreezeNET B130/B300 GigE 17 Operational User Manual
2.8 Telnet Command
Use telnet protocol to enter a remote host.
Syntax:
telnet address [port] [-s source]
Description:
Sets up a connection with a remote host specified by the IP-address in the
terminal emulation mode. The telnet command uses transparent symbols stream
without any intermediate interpretation; therefore, the terminal type is defined by
the terminal from which the command has been executed. To interrupt the
terminal emulation session, press Ctrl/D.
 port - specifies destination port
 source - replaces sender own IP-address with the specified one