User manual

Chapter 2 - General Purpose Command Set Sntp Command
Alvarion BreezeNET B130/B300 GigE 30 Operational User Manual
2.15 Sntp Command
SNTP parameters management.
SNTP support developed in WANFleX lets the system to synchronize the time with
configured NTP server using fourth version of SNTP protocol RFC 2030.
Client works in unicast server request mode in certain time range.
Syntax:
sntp [options] [command]
Commands are the following:
 start - start service
 stop - stop service
Options are the following:
 -server={ipaddr} - set sntp server address
 -interval={seconds} - specify poll interval in seconds
 -debug={on|off} - enable/disable debug information
Example:
sntp -interval=3600 -debug=on
sntp -server=9.1.1.1 start
Commands:
 start
Make the process of time synchronization active.
Example:
sntp start
 stop
Stop the process of time synchronization.