User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Rfconfig Command (Radio Interface Configuration)
Alvarion BreezeNET B130/B300 GigE 40 Operational User Manual
higher than Noise Floor Threshold. See Noise Floor and Noise floor Threshold
values with "rf IFNAME stat" command.
Commands Description:
 statistics: displays current values of the radio module's statistics with 1 sec
interval.
The table below shows the "rfconfig stat" command output:
Table 3-1: “rf stat” output for 5GHz devices
Parameter Description
Broadcast rate Current bitrate value for Broadcast and Multicast packets
Voice Mode ON/OFF value. If turned ON, the mode of their prioritized processing
is turned on
Bytes Received Number of received bytes including headers
Bytes Transmitted Number of transmitted bytes including headers
Packets Received OK Number of correctly received packets
Packets Transmitted OK Number of correctly transmitted packets
Duplicate Received Number of duplicate packets received due to protocol excesses
Aggr duplicates Number of duplicate aggregates received
Aggr drops Number of packet drops in an aggregate due to protocol excesses
(in receiving)
Total Retries Total number of retries
FIFO Overrun Number of FIFO queues overruns in the radio when receiving
FIFO Underrun Number of FIFO queues underruns in the radio while transmitting
CRC Errors Number of received packets with CRC errors
Excessive Retries Number of packets which were not transmitted with maximal number
of retries
Noise Floor Input noise level. Measurement cycle -10 seconds
Noise Floor Threshold Noise Floor Threshold for Carrier Detect
Decrypted frames Number of successfully decrypted packets
Decrypted errors Number of errors in the decryption process
Replay drops Number of packet drops in an aggregate due to the packet sequence
errors