User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC MINT (“mint” command)
Alvarion BreezeNET B130/B300 GigE 50 Operational User Manual
mint rf5.0 start
The following command resets the MINT configuration to default and stops the
transmission:
mint rf5.0 clear
To make the unit transmit again it is necessary to enter "mint rf5.0 start".
3.2.2.11 MINT Log Settings
The following command is used to control log settings for MINT protocol:
mint IFNAME -[no]log [detail]
Three different modes are available:
 No logging. "-nolog" option is used
 Limited logging. "-log" option is used. The messages on
connecting/disconnecting neighbors will be put to the system log
 Detailed logging. "-log detail" option is used. Along with the messages from
limited logging mode, messages on changing costs of the routes and changing
bitrates (in autobitrate) mode will be put to the system log
Example:
mint rf5.0 -log detail
This command will turn full logging on.
3.2.2.12 MINT Protocol Version
Syntax:
mint vers
The command shows current version of MINT protocol.
3.2.3 Nodes Authentication
Setting the secret key:
mint IFNAME -key SECRETKEY
This command sets the secret key for the current node. See different
authentication modes descriptions below to learn how it is being used. The key
can be up to 64 characters long and should not contain spaces (or should be put
in quotes).