User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC MINT (“mint” command)
Alvarion BreezeNET B130/B300 GigE 56 Operational User Manual
 Routes. The following output is displayed:
 Full. A combination of the above modes
 Swg. This option is used when switching groups are created in MINT network.
It shows in which switching groups neighbor node is included:
Parameters:
» -detail - shows the following information for each link with a neighboring
node: distance do the neighboring node in kilometers, load on
receive/transmit in Mbps, on receive/transmit in packets per second, link
"Cost", main IP-address of the neighboring node.
» -m - shows I/O signal levels relative to minimal receive/transmit bitrate.
(Without -m relative to current bitrates).
Mint -[no]colormap option enables/disables color indication of the command:
Figure 3-2: Mint Map Routes Output
Figure 3-3: Mint Map Swg Output