User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Muffer Command (Environment Analyzer)
Alvarion BreezeNET B130/B300 GigE 69 Operational User Manual
Supplementary options for all the above regimes:
 -tXX specifies the duration of time, in seconds, for which the test regime is
enabled (2 minutes by default). The value 0 in this field enables a test regime
for unlimited time.
 -lXX specifies the number of lines on the screen for displaying test results (24
lines by default)
To terminate the analyzer operation in any of the above regimes, press <ESC> or
<Ctrl/C>.
3.4.4 Statistics Module
The statistics gathering is used for estimating link load intensity. The amount of
packets sent and received, and the number of retransmissions is shown for each
MAC-address participating in the data exchange.
The statistics output is presented in the picture below.
Figure 3-10: Muffer Scan Mode