User manual

Chapter 3 - Layer 2 Command Set - PHY and MAC Switch Command
Alvarion BreezeNET B130/B300 GigE 79 Operational User Manual
3.7 Switch Command
This command is used to configure MAC Switch.
Syntax:
________ LIST commands __________________________________
switch list LISTNAME [{iface | mac | numrange | match}]
{add | del} [VALUE ...]
dump [WILDCARD]
rename NEWNAME
file FILENAME
[ flush|remove]
________ GROUP commands _________________________________
switch group GROUPID {add | del} IFNAME[:{TAG|0}] ...
switch group GROUPID {repeater|trunk} {on|off}
switch group GORUPID {(up|down)stream} {SCID|0}
switch group GROUPID vlan {TAG|LIST|0}
switch group GROUPID xvlan {TAG|LIST|0}
switch group ID nvlan {[on]|off}
switch group GROUPID info INFO_STRING
switch group GROUPID setid NEWGROUPID
switch group GROUPID stp { off | on | dump }
switch group GROUPID stp priority [PRIO] #(default: 57344,
step: 4096)
switch group GROUPID stp forwarddelay [DELAY] #(default: 15
sec)
switch group GROUPID stp maxage [TIME] #(default: 20 sec)
switch group GROUPID stp port IFNAME priority [PRIO]
#(default: 128,step 16)
switch group GROUPID stp port IFNAME cost [COST] #(default:
200000(RSTP), 5535(STP))
switch group ID igmp-snooping { off | on }