Installation guide

BreezeNET
®
B130/B300 GigE Quick Installation Guide
- 2 -
P/N: 215743 July 2010
• IDU’s AC power cord with a power plug
• Console cable for having easy direct connection to ODU and performing initial
configuration, link diagnostic, performance monitoring
• ODU mounting kit assembling. Pole, Low diameter pole or Wall mounting kits are available.
In case of using IDU with external antenna:
• Antenna
• Antenna installation kit assembling
• RF low loss cable for connecting antenna to ODU
• Required grounding system
Tools to be available at the installation site.
• Screwdrivers set
• Pliers
• Spanners set
• RJ-45 Crimp Tool (for RJ-45 connectors)
• Connectors sealing set.
• Optional: GPS receiver or area map with compass and alidade
• Optional: Big zoom binocular
Cables preparation
1. In case of installing ODU with external antenna: prepare RF cable of the required length.
RF low loss cable of 1 meter length is recommended. Install and seal the connectors on
the RF cable.
2. Determine the Service cable length that is used to connect IDU and ODU. The total cable
length between LAN equipment (behind IDU) and ODU should not be longer than 100
meters. Service cable should be STP/FTP Category 5E cable.
3. Install a connector for ODU on the Service cable and seal it (see Connector installation
below).