Installation guide

BreezeNET
®
B130/B300 GigE Quick Installation Guide
- 6 -
P/N: 215743 July 2010
8. Install IDU. Provide IDU grounding.
9. Connect Service cable to IDU previously having touched IDU connector case with Service
cable connector case for removing static electricity on the IDU.
WARNING:
Connect UTP-cable with KEYED RJ-45 connectors ONLY to “ODU” port on
the IDU. Do NOT try to connect it to “LAN” port, it will damage Keyed RJ-45
connector or IDU’s port.
10. Connect Ethernet cable to IDU.
11. Connect power cord to IDU. Provide power supply.
12. Connect to the unit using Telnet protocol.
13. Configure basic configuration parameters (see Basic configuration instructions below).
Basic configuration
1. Connect to the ODU via ODU console port using console cable or via IDU LAN Ethernet
port using wired LAN (start Telnet protocol).
2. Configure your computer parameters. If you are using console port start any terminal
emulation software (e.g. Hyper Terminal), set console interface properties to 38400 baud
rate, 8 bit, 1 stop bit, parity off, flow control disabled, enable emulation mode ANSI or
VT100, keyboard VT100. If you are using Telnet protocol from the wired LAN run Telnet
with 10.10.10.1 IP-address that is configured for the Ethernet interface of the device by
default.
3. You will see the WANFleX OS prompt. Enter login and password. Every new device login
“admin” and password “private”. After default authorization there will be standard prompt
string.
4. Perform basic radio interface configuration using “rfconfig rf5.0” command. Basic
parameters: radio frequency (‘freq’ parameter) in MHz, bit-rate (‘bitr’ parameter) in
kBits/sec, system identifier (‘SID’ parameter). ‘SID’ – is a system identifier of the unit (all
units that are supposed to see each other on the same radio link must have the same