Specifications
Table Of Contents

Chapter 2 - Getting Access to the Unit PC/Laptop/LAN Connection
Alvarion BreezeNET B130/B300 GigE 14 Quick Start Guide
10 Your device has a factory configuration. The default login is "admin" and the
default password is "private".
11 Once this is done, you will see WANFleX CLI (Command Line Interface). See
Figure 2-8.
12 In order for your unit to be accessible from your LAN/PC/Laptop via Ethernet,
you should configure eth0 interface IP-address so the unit would allocate in
the desired LAN (or accessible from your PC/Laptop Ethernet adapter). Your
can change this IP-address via "ifc eth0" command as shown on figure 9. After
changing the IP-address, save the configuration using "co sa" command. In
the example given the IP-address being assigned to eth0 interface is 9.1.8.1
with mask length 24 (255.255.255.0). In order to check whether your changes
were correct, use "co sh ifc" command which shows configuration for all
interfaces of the unit. Do not forget to save your configuration using "co sa"
(config save) command.
Figure 2-7: WANFleX OS Prompt
Figure 2-8: WANFlex CLI