Specifications

Chapter 3 - Point-to-Point Configuration Providing IP Connectivity
Alvarion BreezeNET B130/B300 GigE 35 Quick Start Guide
3.3.2 Switched Link
MINT architecture has an ability of using switching capabilities. Switch, realized
in the units, is a very powerful tool that can be used in many different scenarios
but in this particular example we will be using it for one simple purpose - create a
simple switched link. The following steps should be taken:
1 Configure IP-addresses (e.g. on eth0 interface) from the same subnet. Say,
9.1.8.1/24 for the first unit and 9.1.8.2/24 for the second one.
2 On both units the switch needs to be configured. Although, switch realized in
the units is a powerful tool and can be used for many different purposes, here
in our example, we will use the simplest configuration which turns the unit to
a full switch mode. The following set of commands should be executed on both
units in the link:
switch group 1 add eth0 rf5.0
switch group 1 start
switch admin-group 1
switch start